Art Dualxdirect Can You Use It With Guitar Cabs?

The DUALXDirect provides 2 independent high quality active interfaces that let you connect instrument, line, or speaker level signals to a mixer or other counterbalanced inputs. Each of the high impedance i/4" and XLR inputs (provided via "combo" jacks) are buffered and converted by very low noise active electronics into an isolated, balanced, low impedance signal output. The DUALXDirect has an extremely flat and wide frequency response and can handle loftier point levels. This gives the DUALXDirect a very make clean and neutral sound with a broad diverseness of point sources and over long signal runs in high noise environments.

The input ATTENUATOR switches permit for a wide range of signal levels and the input THRU jacks permit for tapping off of your signal chain. The Ground LIFT switches let you lot totally separate the input and output bespeak grounds, when appropriate, to isolate two systems, thereby reducing hum and footing-loop noise.

The DUALXDirect''southward agile circuitry is powered by phantom voltage from the OUTPUT connections or by an internal 9V battery, when external power is not bachelor. When powered by a battery, it draws less than 7.5 mA which should provide more 100 hours of functioning with a new battery (alkali metal recommended). If phantom power is bachelor, then the DUALXDirect will automatically draw its power from the external source. The Power ON/OFF switch lights more dimly when the unit is running off of the battery, lights more than brightly when it is running off of phantom power, and is off when the unit is inactive.

The compact black-anodized all aluminum example and it'south active design allow the DUALXDirect to provide years of trouble free service in Live Audio, Permanent/Fixed Install, D.J., and well-nigh any PA application. It'due south full feature fix, rugged construction, and loftier-end specifications make the DUALXDirect the obvious choice.

FEATURES:
• Fully active design
• Phantom voltage or 9V battery powered
• Converts high-impedance balanced / unbalanced inputs into 600 Ohm balanced outputs
• Switchable input attenuation (0, -30 dB)
• Switchable basis lift
• one/iv" TRS / XLR philharmonic connector inputs
• XLR connectors for balanced outputs
• Rugged extruded aluminum instance

SPECIFICATIONS:
• Frequency Response: 10 Hz - 100 kHz, 0.five dB @ +0 dBu
• THD: <.05% (typical)
• Dynamic Range: >100 dB (typical)
• Channel Separation: > 80 dB (typical)
• Maximum Input Level: +4, +34 dBu
• Maximum Output Level: +6 dBu (battery powered), +fourteen dBu (phantom powered)
• Input Connections: one/4" TRS | XLR female balanced / unbalanced (two), 470k Ohm
• Thru Connections: 1/iv" TRS (2)
• Output Connections: XLR male counterbalanced (2), <600 Ohm
• Input Attenuation: Switchable, (0, -thirty dB)
• Ability Requirements: 9V @ vii.5 mA (battery, alkaline recommended), 18 - 48V DC @ half dozen.4 mA (phantom power per channel)
• Dimensions (DWH inches): three.9 x 4.half-dozen x 1.85
• Dimensions (DWH mm): 99 x 117 x 47
• Weight: 0.84 lbs / 0.38 kg

At that place are currently no reviews for this production, be the first to write ane!

Protect your investment with the Long & McQuade Performance Warranty

A warranty tin be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one yr limited warranties that generally only encompass items that malfunction due to a manufacturer'south defect. With an of import purchase such as a musical
instrument or slice of studio gear, nevertheless, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.

Considering of this, Long & McQuade provides our customers with a FREE i-year Operation Warranty on about of our products. The Long & McQuade Operation Warranty supplements the manufacturer'southward warranty to ensure that our customers receive complete "no hassle" warranty coverage within their showtime year.

How does the Long & McQuade Functioning Warranty differ from well-nigh manufacturers' warranties?

• Functioning Guarantee: Normal vesture and tear is covered, and so your product will exist performing equally well as the twenty-four hours you purchased information technology for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for contumely instruments volition be provided if deemed necessary by our repair staff, simply is not routinely offered under the Performance Warranty.
• Product Replacement: If your production cannot exist fixed or costs also much to set up, we will replace it with the equivalent model for no boosted charge. If this is non possible, a total refund will be provided.
• No Lemon Policy: Your product will be replaced should the same trouble occur multiple times.
• Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
• Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
• Loaners Available: A loaner product may be given while the production is being repaired.
• Power Surge Protection: Your product is covered even if damaged from a power surge.
• Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are as well covered.
• Commercial Use Coverage: Music and recording professionals who purchase gear for "heavy-use" commercial purposes volition all the same be covered.

Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.east. computers, software, cymbals and other items) are covered only by the manufacturer's warranty. Consumables (i.e. strings, reeds, pulsate sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused past Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally non covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Operation Warranty is no longer transferable. The warranty is only valid in Canada.

Purchasing boosted years of coverage

Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that practice not provide the same coverage as the Long & McQuade Functioning Warranty. Customers interested in more complete and convenient (but non necessarily longer) coverage are all the same able to buy boosted years of the Performance Warranty.

If you are interested in receiving this coverage for longer than one year, you accept the option of purchasing additional years of the Performance Warranty. The pricing is equally follows:

• NEW products: 4% of the current new selling price to double the warranty from 1 twelvemonth to 2 years. 4% for each additional year.
• USED products: 4% of the electric current new selling price to increment the warranty from 3 months to 1 year. 4% for each additional year. Pricing for used electronic products is 4% of the original new selling price.
• GUITARS: iv% of the current new selling price to double the warranty from i twelvemonth to 2 years. 4% for each additional year. $45 maximum. An boosted free setup is non included with additional purchased years of Performance Warranty.
• BAND and ORCHESTRAL instruments: $40 flat charge per unit up to $2,000 of current new selling cost to double the warranty from 1 twelvemonth to 2 years.
• Contumely and STRINGS: ii% of the current new selling price above $2,000.
• WOODWINDS: 4% of the current new selling price above $2,000.

acostagraccer.blogspot.com

Source: https://www.long-mcquade.com/12383/Pro_Audio_Recording/Mic_Preamps_DI_Boxes/ART_Pro_Audio/Active_DI.htm

Share this post